Black & Decker CS1012 User Manual

Page 9

• While keeping the saw in this position,

unplug the saw and loosen the kerf
plate on the saw shoe.

• Align the 0° mark (22) on the kerf plate

with the cutting line. When adjusting
for 45° miter cuts, align the 45° mark
(23) on the kerf plate with the cutting
line.

• Secure the kerf plate using the screw

(24).

SAWING

WARNING: To reduce the risk of

serious personal injury,always hold the
tool with both hands.
• Let the blade run freely for a few

seconds before starting the cut.

• Apply only a gentle pressure to the tool

while performing the cut.

• Work with the shoe pressed against

the workpiece.

HINTS FOR OPTIMUM USE

• As some splintering along the line of

cut on the top side of the workpiece
cannot be avoided, cut on the side
where splintering is acceptable.

• Where splintering is to be minimized,

e.g. when cutting laminates, clamp a
piece of plywood onto the top of the
workpiece.

POCKET CUTTING (FIG.12)

POCKET CUTTING IS USED TO CUT A
HOLE IN A PIECE OF MATERIAL
WITHOUT CUTTING FROM THE SIDE.

• Measure and mark work.
• Tilt saw forward and rest front of the

shoe on material to be cut. Align so
that cut will begin at the back of the
drawn rectangle shown in figure 12.

• Using the retracting lever, retract blade

guard to an upward position, with the
blade just clearing the material, start
motor and gradually lower the saw into
the material.

WARNING:

As blade starts cutting the

material, release the retracting lever
immediately.

• Never tie the blade guard in a raised

position.

• When the shoe rests flat on the

material being cut, complete the cut in
forward direction.

• Allow the blade to come to a complete

stop before lifting saw from material.

• When starting each new cut, repeat the

above steps.

WRENCH STORAGE (FIG.13)

The spanner wrench (8) can be stored
on the saw shoe as shown in figure 13.

MAINTENANCE

Use only mild soap and damp cloth to
clean the tool. Never let any liquid get
inside the tool; never immerse any part of
the tool into a liquid.
IMPORTANT: To assure product
SAFETY and RELIABILITY, repairs,
maintenance and adjustment (other than
those listed in this manual) should be
performed by authorized service centers
or other qualified service organizations,
always using identical replacement parts.

LUBRICATION

Black & Decker tools are properly
lubricated at the factory and are ready for
use.

90511917 CS1012 5/7/07 9:32 AM Page 9