Blaupunkt 2000 DJ - Manual (Page 23)

64
RELIGION
PHONE IN
TRAVEL
LEISURE
JAZZ MUSIC
COUNTRY MUSIC
NATIONAL MUSIC
OLDIES MUSIC
FOLK MUSIC
DOCUMENT
Checking the program type of the sta-
tion
On menu level 2
•
Press PTY for approx. 2 seconds.
After the beep tone the display will show the
program type offered by the station current-
ly playing.
If “NONE” appears in the display, the cur-
rent station has no PTY code.
Displaying the selected program type
• Press << or >>.
The program type selected last will be dis-
played briefly.
Selecting a program type
a) Using the preset buttons
When PTY is switched on, you can use
the preset buttons ST1 - ST6 to select
the program types stored at the facto-
ry.
• Press one of the presets 1-6.
The selected program type will be dis-
played for 2 seconds.
If you would like to listen to a station
with this PTY,
• press / to start the seek tuning
function.
If the radio is unable to find a station offer-
ing the selected program type, the display
will show “NO PTY” and a beep tone will be
emitted. The radio will select the station
which was tuned into before seek tuning was
activated.
You can assign different program types to
each preset position. Please refer to the next
section on “Storing program types”.
b) Using the << >> buttons on the rocker
switch
When PTY is switched on, you can se-
lect a program type using buttons
<< >>.
• Press << or >>; the program type se-
lected last will be displayed for 3
seconds.
Radio operation with RDS (Radio Data System)
• During this period press >> (for-
wards) or << (backwards) to select
the desired type.
• Press << or >> as many times as re-
quired.
If you would like to listen to a station
with the selected PTY,
• press / to start the seek tuning
function.
If the radio is unable to find a station offer-
ing the selected program type, the display
will show “NO PTY” and a beep tone will be
emitted. The radio will select the station
which was tuned into before seek tuning was
activated.
Storing program types
Each of the preset buttons ST1 - ST6 has
been assigned one program type at the fac-
tory.
If desired, you can also replace these with
other available program types.
To do so, make sure that “PTY” lights up in
the display.
•
If necessary, press the PTY button to
switch on the function.
• Select a program type using buttons
<< >> and
• hold down the desired preset button
(ST1-ST6) until you hear a beep.
ChicHanKanMonParis gb 95%® 14.05.2002, 14:25 Uhr 64