Britax Diplomat User Manual
Page 26
24
Consult your vehicle’s owner’s manual for
approved tether-anchorage locations.
Locate the tether on rear of restraint
and place up and over seat back while
securing restraint.
Secure child restraint by a seat-belt or
LATCH system.
Lift lock adjuster, then pull to fully extend
tether strap into a "V" shape.
Locate hook on strap and loosely attach
tether to an approved anchor point.
See figure A for forward-facing installation.
See figures B and C for rear-facing
installation.
NOTE:
Rear-facing installation may also require
use of Tether Connector Strap, as described on
page 25.
Pull Versa-Tether strap to remove all
slack.
Verify there is tension in Versa-Tether
strap and that child restraint is properly
secured. The restraint is secure when it
cannot be moved front-to-back or side-
to-side more than 1 inch (2.5 cm.) at
belt path. If restraint is not secure, repeat
procedure or use an alternate seating
location.
Roll up excess webbing and store in tether pouch.
1�
2�
3�
4�
5�
•
•
6�
7�
8�
Using the Versa-Tether
Installation: Versa-Tether
®
A
B
C