Buffalo Technology LinkStation Pro Duo LS-WTGL/R1 - Manual (Page 19)

1
Initialization - You can easily bring your LinkStation back to
factory settings with the following steps.
1. Move the power switch to the ‘Off’ position. The LinkStation
will shut down after about 90 seconds.
2. While holding down the function button, move the power
switch to the ‘On’ postion. The function LED on the front of the
LinkStation will begin to flash blue.
3. While the Function LED is still flashing, hold down the
function button for six seconds.
Dismount - Before disconnecting USB devices from the LinkStation, they should be dismounted.
Hold the function button down until the function LED glows blue, and then turns off. It’s now
safe to unplug your USB device.
Note: Unplugging USB devices without dismounting them first may corrupt your data!
Function
Button
Power
Switch
Using the Function Button