Braun Hot Beverage Machine - Manual (Page 5)

Auto
Manual
Heating
Standby
MA X
0
Ma
Auto
T ASSIMO
click
Auto
Preparing your machine for use
4 Preparing your machine for use Preparing your machine for use 5
PLEASE NOTE:
• For some drinks, the brew cycle includes a 5
to 10 second pause after the initial influx of
water. This pause is normal and allows the
water to fully saturate the product before
brewing continues.
• Never open the brew mechanism during brewing.
In “Auto Mode,” always wait for the indicator light
to move from AUTO to MANUAL before opening
the brew mechanism. In “Manual Mode,” take
your finger off the start /stop button and wait
until the machine has stopped before opening
the brew mechanism.
• Always use care when removing your finished beverage.
The beverage may be hotter than you expect.
• After 10 minutes of non-use, the STANDBY light
will illuminate. If you are not going to use your
machine for an extended period, turn it off using
the on/off switch.
• This appliance is intended for household use only.
• Place the appliance on a dry, flat and fixed surface
and keep it out of reach of children.
• Never use warm water, sparkling water or milk to fill
the water container.
• This machine is not suitable for use at altitudes
above 6500 feet/2000 meters.
• Braun electric appliances meet applicable
safety standards. Repairs on electric appliances
(including cord replacement) must only be
carried out by authorized Braun service centers.
Faulty, unqualified repair work may cause
accidents or injury to the user.
IMPORTANT
Before using your Tassimo machine for the first time, it must be prepared by
following the procedure below. Note: it is normal for all the lights to flash when
you turn on the machine. Complete these simple steps to begin enjoying your favorite drinks.
1 Rinse the water container, fill it to “max” with fresh,
cold water and place it on the machine. Check that the
water container is properly inserted in the slot on the
back of the machine. Connect the machine to the
electrical supply and press the on/off switch located on
the back of the machine. All the indicator lights will flash.
2 Place a large cup (at least 11 oz/325 ml) on the adjustable
cup stand. Open the brew mechanism, position the
cleaning disc (included in your package) on the T-DISC
holder, bar code facing down. Firmly close the brew
mechanism by pressing the clamp down until it shuts.
3 Wait five seconds then press and release the start /
stop button to start the machine. You will hear the
machine run for a short period to fill the internal water
heater. When the machine stops running, the STANDBY
light will illuminate.
4 Open the brew mechanism and close it again, leaving
the cleaning disc in place. The orange HEATING light
will begin to flash. Wait about a minute until the green
AUTO light illuminates, then press and release the
start /stop button. The machine will fill the cup with
water. When the machine stops running, empty the cup
and place it back on the adjustable cup stand. Repeat
this step once more in its entirety.
5 Open the brew mechanism and remove the cleaning
disc. The HEATING light will illuminate. Your machine is
now ready to use.
Do not discard the cleaning disc after use – you will
need it for flushing and descaling the appliance.