beautypg.com

Whirlpool WRF991BOOM User Manual

Page 17

background image

17

Recommended Freezer Temperature

Adjust Temperature Set Points

Refrigerator set point range: 33°F to 45°F (0°C to 7°C).
Freezer set point range: -5°F to 5°F (-21°C to -15°C).
1. When Temperature mode is activated, press TEMPERATURE

to select the Refrigerator zone. The display will show the
temperature set point of the selected compartment, as shown.

2. Press LOCK to raise the set point, or press OPTIONS to lower

the set point.

3. When you have finished viewing (and adjusting if desired) the

refrigerator set point, press TEMP, under Select Zone, to
change the display to show the freezer set point. When the
zone has been changed, “FREEZER” appears on the display
screen.

4. Press the LOCK button to raise the set point, or press the

OPTIONS button to lower the set point.

Save/Confirm Temperature Settings

When you have finished adjusting both the refrigerator and
freezer set points, press MEASURED FILL to confirm and to
save the settings.

NOTE: To exit Temperature mode without saving changes, press
the ICE/WATER button under Back at any time, or allow about
60 seconds of inactivity. The temperature mode will turn off
automatically and return to the normal screen.

When adjusting temperature set points,

use the following chart as a guide:

Cooling On/Off

Your refrigerator and freezer will not cool when cooling is
turned off.

To turn cooling off, press and hold the LOCK and MEASURED
FILL buttons at the same time for 3 seconds. The Cooling Off
icon will blink seven times and then remain lit as shown.

IMPORTANT:

To avoid unintentionally locking the dispenser or changing
other settings, press both buttons at exactly the same
time.

When cooling is off, the dispenser paddles and all controls
except Lock and Measured Fill are disabled.

Press and hold LOCK and MEASURED FILL for 3 seconds
again to turn cooling back on.

Options

Press the OPTIONS button to open the Options menu and select
between Fast Ice, Filter Status or Vacation mode.
Press the ICE/WATER button at any time to return to the Normal
screen.

Fast Ice

The Fast Ice feature assists with temporary periods of heavy ice
use by increasing ice production.

To turn on the Fast Ice feature, press the OPTIONS button to
access the Options menu, then press TEMP, under Fast Ice to
activate the feature. When the feature is on, the Fast Ice icon
will appear on the dispenser display screen. The Fast Ice
feature will remain on for 24 hours unless manually turned off.

To manually turn off the Fast Ice feature, press the OPTIONS
button to enter Options mode (unless you are already in
Options mode), then press TEMP, under Fast Ice, again. When
the feature has been turned off, the Fast Ice icon will
disappear from the dispenser display.

Filter Status

Displays the percentage of use remaining in the water filter (from
100% remaining to 0% remaining).
To access Filter Status, press the OPTIONS button to access the
Options menu, then press OPTIONS, under Filter Status, to
display the percent of life remaining in the water filter.
ALSO

The water filter status lights will let you know when to change your
water filter.

ORDER FILTER (Yellow) - Order a replacement water filter.

REPLACE FILTER (Red) - Replace the water filter. Replacing
the disposable water filter will automatically reset the water
filter status tracking feature. See “Water Filtration System.”

CONDITION:

TEMPERATURE
ADJUSTMENT:

REFRIGERATOR too cold

REFRIGERATOR Setting
1° higher

REFRIGERATOR too warm

REFRIGERATOR Setting
1° lower

FREEZER too cold

FREEZER Setting
1° higher

FREEZER too warm /
Too little ice

FREEZER Setting
1° lower

A. Press LOCK and MEASURED FILL at the same time.

This manual is related to the following products: