Installation instructions, Tools and parts, Location requirements – Whirlpool LER3622PQ User Manual
Page 4: Warning
4
INSTALLATION INSTRUCTIONS
Tools and Parts
Tools needed
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Parts supplied
Remove parts package from the dryer drum. Check that all parts
listed are included.
■
1 - Cycle Control (timer) knob
■
1 - Push to Start button
■
4 - Leveling legs
Parts needed
Check local codes, existing electrical supply and venting, and
see “Venting Requirements” and “Electrical Requirements”
before purchasing parts.
Mobile home installations require
■
Metal exhaust system hardware. For ordering information,
please refer to the “Assistance or Service” section of this
manual. You may also contact the dealer from whom you
purchased your dryer.
Location Requirements
You will need
■
A location that allows for proper exhaust installation. See
“Venting Requirements.”
■
A separate 30-amp circuit.
■
A grounded electrical outlet located within 2 ft (61 cm) of
either side of the dryer. See “Electrical Requirements.”
■
A sturdy floor to support the dryer weight (dryer and load) of
115 lbs (52 kg). The combined weight of a companion
appliance should also be considered.
■
A level floor with a maximum slope of 1" (2.5 cm) under entire
dryer.
Do not operate your dryer at temperatures below 45ºF (7ºC). At
lower temperatures, the dryer might not shut off at the end of an
automatic cycle. Drying times can be extended.
The dryer must not be installed or stored in an area where it will
be exposed to water and/or weather.
Check code requirements. Some codes limit, or do not permit,
installation of the dryer in garages, closets, mobile homes or
sleeping quarters. Contact your local building inspector.
■
Flat-blade screwdriver
■
#2 Phillips screwdriver
■
Adjustable wrench
■
Wire stripper (direct wire
installations)
■
Level
■
¼" nut driver
■
Vent clamps
■
Caulking gun and
compound (for installing
new exhaust vent)
■
Tin snips (new vent
installations)
■
Wood block
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the floor
for a garage installation.
Failure to do so can result in death, explosion, or fire.