Whirlpool W10292391 - Manual (Page 3)

3
ARMOIRE KIT SAFETY
INSTALLATION REQUIREMENTS
The Armoire-Style Door Panel Kit for fully integrated Jenn-Air
refrigerators enables full-height custom door panels with a hidden
top panel for the ultimate in integrated design.
IMPORTANT:
■ These instructions will guide you in preparing your built-in
refrigerator for an armoire installation. They are intended to
supplement the Installation Instructions provided with your
refrigerator not replace them.
■ These instructions are intended as a general guide only and
do not supersede any national or local codes in any way.
Compliance with all local, state or national codes pertaining to
this type of installation should be determined prior to
installation.
Tools and Parts
Assemble the required tools and parts before starting installation.
Read and follow the instructions provided with any of the required
tools listed here. Proper installation is your responsibility.
Tools Needed:
Parts Supplied with Armoire Kit:
Parts Supplied with Refrigerator - Used in Armoire
Installation:
Parts Supplied with Refrigerator - Not Used in Armoire
Installation (these parts can be discarded):
You can be killed or seriously injured if you don't immediately
You can be killed or seriously injured if you don't follow
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”
These words mean:
follow instructions.
instructions.
DANGER
WARNING
■ Cordless drill
■ Drill bits
■ Two adjustable
wrenches
■ Phillips screwdriver
■ Small level
■ Appliance dolly
■
³⁄₃₂" Hex key
(panel kits only)
■
¹¹⁄₃₂" Nut driver
■
³⁄₈" and ¹⁄₂" Open-end
wrenches
■
⁵⁄₃₂" and ³⁄₁₆" Hex key
■
¹⁄₄" and ⁵⁄₁₆" Socket
drivers
■ Tape measure
■ Utility knife
■ Tape (painters)
■ Grille Assembly ■ Grille Bracket Assembly
■ Instructions
■ All hardware
■ Drawer panel bracket
■ Panel top bracket
■ Hinge cover trim (RC and FC)
■ Side trim
■ Handle side door trim
■ Installation block
■ Panel templates
■ Standard grille bracket ■ “L” brackets
■ Integrated grille bracket ■ Grille trim