Neff S41M63N1GB - Manual (Page 23)

Operating the appliance en
23
Remaining running time
display
When the programme is selected, the
remaining running time of the
programme is indicated on the digital
display )*.
The running time is determined during
the programme by the water
temperature, the number of utensils as
well as the degree of soiling and may
vary (depending on the selected
programme).
Timer programming
Timer programming *
* depending on model
You can delay the start of the
programme in 1-hour steps up to
24 hours.
1. Close the door.
2. Switch on ON/OFF switch (.
3. Press button X + until the digital
display )* jumps to œ:‹‚.
4. Press X + or – button until the
displayed time corresponds with your
requirements.
5. Press START button h, timer
programming is activated.
6. To delete timer programming, press
the X + or – button until )* œ:‹‹
is indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.
End of programme
The programme has ended when the
value
‹:‹‹ is indicated on the numerical
display )*.
Automatic switch off after end
of programme or interior light*
Automatic switch off / interior light
* depending on model
To save energy, the dishwasher can be
automatically switched off 1 min or 120
min after the programme ends.
The setting can be selected from
˜:‹‹
to ˜:‹ƒ.
1. Close the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button h
until
•:‹... is indicated on the digital
display.
4. Release both buttons.
The LED for button # flashes
and the digital display )* displays
the factory setting
•:‹….
5. Keep pressing programme
button # until the value ˜:‹... is
indicated on the numerical display
)*.
˜:‹‹ Appliance does not
switch off automatically.
The interior light 1"
comes on when the door
is opened irrespective of whether
the ON/OFF switch (
is switched on or off. When
the door is closed the light is off. If
the door is open for longer than 60
min., the light switches off
automatically. The interior light 1"
is lit only when the set value
˜:‹‹
is selected.
˜:‹‚ Appliance switches off after 1 min.
˜:‹ƒ Appliance switches off after 120
min.