Pans, Bottom basket 1b, Cutlery drawer – Neff S72T69X3GB User Manual

Page 9: The drawer can be taken out, Rinse aid

As soon as the rinse-aid refill indicator P
is lit on the fascia, there is still a rinse-aid
reserve of 1 – 2 rinsing processes. Refill
with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses. Use only rinse
aid for domestic dishwashers.
Combined detergents with rinse-aid
component may be used up to a water
hardness of 21° dH (37° fH, 26° Clarke,
3.7 mmol/l) only. If the water hardness is
over 21° dH, rinse aid must be used.
–

Open the dispenser 1j by pressing
and lifting the plate on the cover.

–

Carefully pour rinse aid up to the max.
mark in the filler opening.

–

Close cover until it clicks shut.

–

To prevent excessive foam formation
during the next rinse cycle, remove any
rinse aid which has run over with a
cloth.

Setting amount of rinse aid

The amount of rinse aid can be set from

§:‹‹ to §:‹‡. Please set rinse aid on

§:‹† to obtain very good drying results
(

§:‹† is already set in factory).

Change this setting, only if streaks (select
lower setting) or water stains (select higher
setting) are left on the utensils.
–

Open the door.

–

Switch on ON/OFF switch (.

–

Hold down programme button # and
press START button )" until

•:‹.... is

indicated on the digital display.

–

Release both buttons.
The LED for button # flashes and the
digital display 8 displays the factory
setting

•:‹….

–

Press programme button # until the
factory set value

§:‹† is indicated on

the digital display 8.

To change the setting:
–

Press programme button 3.
Each time the button is pressed, the
set value increases by one level; when
the value of

§:‹‡ has been reached,

the display jumps back to

§:‹‹ (off).

–

Press START button )".
The set value is saved.

–

Close the door.

Switching off rinse aid refill
indicator

If the rinse-aid refill indicator P is
impaired (e.g. when using combined
detergents containing rinse aid
component), it can be switched off.
–

Proceed as described under “Setting
amount of rinse aid” and set the value
to

§:‹‹.

The rinse aid refill indicator P is now
switched off.

Rinse aid %

PD[