Neff I89DK62N0B - Manual (Page 5)

5
Operation
These instructions apply to several appliance variants. It is
possible that individual features are described which do not
apply to your appliance.
Note: Switch on the extractor hood when you start cooking and
switch it off again several minutes after you have finished
cooking. This is the most effective way of removing the kitchen
fumes.
Control panel model 1
Control panel
Setting the fan
Switching on the appliance
■
Press the # button.
The fan starts at setting ƒ .
■
Press the + or - button to change the fan strength.
Switching off
Press the
# button.
Intensive setting
You can use the intensive setting if there is a large build-up of
odours and fumes/vapours.
Press the + button when the fan is at setting
„ .
The intensive setting ˜‚ is activated. Pressing the + button
again activates the intensive setting ˜ƒ .
After approx. six minutes, the electronics automatically reduce
the fan to a lower setting . If you want to end the intensive
setting before the preset time expires, press the - button until
the required fan setting is reached.
Fan run-on time
Press the - button until – appears.
After approx. ten minutes, the fan switches off automatically.
AirFresh function
Press the - button until 3‚ appears. The fan runs for approx.
five minutes per hour.
If you want to end the AirFresh function, press the
# button.
Lighting
The lighting can be switched on and off independently of the
fan.
Press the
A button.
Setting the brightness
Press and hold the
A button until the desired brightness is
reached.
Saturation display
When the metal mesh grease filters or the activated carbon
filter are saturated, a signal sounds for approx. 4 seconds after
the fan is switched off. In addition, this symbol is indicated on
the display: ª
If you have not yet done so, the metal mesh grease filters
should be cleaned now.
For instructions on how to clean the metal mesh grease filters,
please refer to the section Cleaning and maintenance.
While the saturation display is flashing, it can be reset. To do
this, press the – button.
Audible signal
Switching on the acoustic signal
When the fan is switched off, press the
# and + at the same
time for approx. three seconds. An acknowledgement signal
sounds.
Switching off the acoustic signal
Repeat the "Switching on the acoustic signal" process.
Explanation
# Fan on/off
- Reduce the fan settings/fan run-on time/interval ventila-
tion
+ Increase the fan settings/intensive setting 1, 2
A Light on/off/dimming
IUHVK
YRO