Neff V7446X0GB - Manual (Page 3)

1
Safety instructions
– The washer dryer is heavy – take care when lifting it.
– Warning: frozen hoses may tear/burst. Do not install the washer dryer outdoors or in areas
where there is a risk of frost.
– The washer dryer may be damaged. Do not lift by projecting components (e.g. washer dryer
door).
– In addition to the instructions mentioned here, special regulations of the relevant water and
power supply companies may apply.
– If in doubt, have the appliance connected by a technician.
– Lay hoses and cables in such a way that there is no risk that they can be tripped over.
Environmental disposal
– Dispose of packaging in an environmentally friendly manner.
– This appliance has been identified in accordance with the European Directive
2002/96/EEC on Waste Electrical and Electronic Equipment (WEEE). The Directive
specifies aâframework for the return and recycling of waste appliances and is valid
throughout Europe.
Scope of delivery
according to model
Humidity in the drum is caused
byâthe final inspection.
Depending on the connection
– Aâ24–40 mm dia. hose clip may also be required for connecting the siphon (available from
specialist retailers). a Pageâ4: Water connection
Useful tool
– Spirit level for aligning the washer dryer.
– Wrench for adjusting the machine feet.
Water drainage
Power cord
Water supply
Covers
Hose holder
Aqua-Stop Aqua-Secure Standard
2
Installation area
– Stability is important to prevent the machine from wandering.
– The installation area must be firm and level.
– Soft floors/floor coverings are not suitable.
– Ensure the area is well ventilated to achieve good drying performance.
If installing the appliance on a pedestal
– It is essential to secure the washer dryer feet with holding bracketsâ*.
If installing the appliance on a wooden joist floor
– If possible, install the washer dryer in a corner.
– Screw a water-resistant wooden panel (min. 30 mm thick) to the floor.
– It is essential to secure the washer dryer feet with holding bracketsâ*.
*âorder no. WMZ 2200, WX 9756
Hose and cable lengths
Connection on left side or Connection on right side
Note: if hose holders are used, the hose lengths may be reduced.
Available from dealer/customer service:
– Aqua-Stop extension hoseâ**, approx. 2.50 m.
– Longer supply hose, approx. 2.20 m, for standard model.
**âorder no. WMZ 2380, WZ 10130
Built-under/Built-in appliance
Build-under/build-in before connection to the power supply.
Installed in between kitchen units (built-under or built-in)
– Dimension requirement of kitchen unit:
aв=в650вmm, bв=в620вmm, cв=в850вmm
– Install washer dryer only under a continuous worktop that
is connected firmly to the adjacent cupboards.
– The installation area must be well ventilated, otherwise the
washer dryer will operate below optimum performance.
Dimension of ventilation cross-section:
d x e = 200 mm x 100 mm, f = 365âmm
Distance between wall and machine: 50âmm
~140 cm
~160 cm
~140 cm
~90 cm
~165 cm
~95 cm
m
ax
. 1
0
0
c
m
m
in
. 6
0
c
m
f
e
a в
в в
в в
в в
в
в
ʑ
ʑ
a â
ʑ
a â
ʑ
ʑ
ʑ
ʑ
ʑ