Neff S72T69X3GB - Manual (Page 31)

Fault, what to do? en
31
Water stains on plastic
parts Droplet formation on plastic
surface is physically unavoidable.
After drying, water stains are
visible. Use a more intensive programme (more
water changes).
Arrange utensils in a sloping position.
Use rinse aid.
If required, increase softening setting.
Washable or water-soluble
coatings in the container or
on the door. Detergent substances are
deposited. These coatings cannot
usually be removed with
chemicals (appliance cleaner, ...). Change detergent brand.
Clean appliance mechanically.
If there is a “white coating” on
the container floor, the water
softening system has been set
marginally. Increase softening setting and change
detergent if required.
Salt dispenser cover 1R not
closed. Close salt dispenser cover correctly.
Only for glasses: Initial glass
corrosion – can only apparently
be wiped off. See Glass and utensil damage.
White, stubborn coatings;
limescale on the utensils,
container or door. Detergent substances are
deposited. These coatings cannot
usually be removed with
chemicals (appliance cleaner, ...). Change detergent brand.
Clean appliance mechanically.
Hardness range incorrectly set or
water hardness greater than
8.9 mmol/l. Set water softening system according
to instructions for use or top up salt.
3 in 1 detergent or bio/eco
detergent not effective enough. Set water softening system according
to instructions for use or use separate
detergents (proprietary detergent, salt, rinse
aid).
Underdosing of detergent. Increase detergent dosage or change
detergent.
Too weak rinse programme
selected. Select a more intensive rinse programme.
Tea or lipstick residue on
the utensils. Too low rinsing temperature. Select programme with higher washing
temperature.
Too little or unsuitable detergent. Use suitable detergent at correct dosage.
Utensils precleaned too intensely;
sensors therefore decide on
weak programme sequence.
Stubborn soiling cannot be
completely removed. Do not prerinse utensils. Remove only large
food remnants.
Recommended programme Eco 50°
Fault Cause Remedial action