Installation, Frost protection / transport, Technical data – Neff R8580X1GB User Manual
Page 8: Consumption rates, Optional accessories, ʠ ʠ ʠ
ʑ
ʑ
a
a
u
a
u
10
Installation
– Scope of delivery: dryer, installation and instruction manual, jug, basket for woollens
(depending on the model).
– Check dryer for transport damage.
– The dryer is heavy. Do not attempt to lift it on your own.
– Be careful to avoid sharp edges.
– Do not install in a room where there is a risk of freezing. Freezing water may cause damage.
– If in doubt, have the appliance connected by a specialist.
– Do not lift the dryer by protruding parts (e.g. the door) - risk of breakage.
Setting up the dryer
– The appliance plug must always be accessible.
– Ensure that the appliance is installed on a clean, level
and firm surface.
– Keep the cooling grille on the front of the dryer
clear.
– Keep the area around the dryer clean.
– Level the dryer using the threaded feet.
Use a spirit level.
– Do not remove the threaded feet under any
circumstances.
Mains connection
see safety information a page 13.
– Connect to an AC earthed socket. If in doubt, have the socket checked by a specialist.
– The mains voltage and the voltage shown on the rating plate (a Page 11) must be the same.
– The connected load and necessary fuse protection are specified on the rating plate.
Frost protection / Transport
Preparation
1. Empty the condensation container a page 4.
2. Select any programme using the programme selector.
3. Press the Start/Stop button a condensation is pumped into the container.
4. Wait 5 min., and then empty the condensation container again.
5. Turn the programme selector to Off.
The water tank must not contain any distilled water. If necessary, run the Steam/Refresh programme.
1.
Remove all accessories
from the drum.
The drum must be empty.
Make sure that the air inlet
remains unobstructed
Clean and level
Do not install the dryer behind a door or sliding
door, which could prevent or restrict opening of the
dryer door. This will prevent children from locking
themselves in and putting their lives in danger.
2.
Do not operate the dryer if there
is a danger of frost.
11
Technical data
ʠ
Dimensions (DxWxH)
60 x 60 x 85 cm (adjustable height)
Weight
approximately 43.5 kg
Max. capacity
7 kg
Condensation container
4.0 l
Water tank
approx. 0.4 l
Connection voltage
220-240 V
Connected load
max. 2600 W
Fuse protection
13 A
Ambient temperature
5 - 35 °C
Product number
Production number
Inside of door
The rating plate can be found on the back of the dryer.
ʠ
Drum interior light
(depending on model)
(bulb E14, 25 W)
The drum lights up after the door is opened or closed, and after the programme starts,
and switches off automatically. Changing the bulb
a
page 12.
Consumption rates
(The value on the label is achieved at the maximum heat setting.)
Fabrics/programmes
Residual moisture in the
fabrics after spinning
Drying time**
Energy
consumption**
Cottons 7 kg
13 A
13 A
Cupboard Dry*
1400 U/min
(50%)
106 min
3.60 kWh
1000 U/min
(60%)
124 min
4.20 kWh
800 U/min
(70%)
143 min
4.80 kWh
Iron Dry*
1400 U/min
(50%)
82 min
2.59 kWh
1000 U/min
(60%)
98 min
3.28 kWh
800 U/min
(70%)
112 min
3.96 kWh
Easy-Care 3.5 kg
Cupboard Dry*
800 U/min
(40%)
42 min
1.35 kWh
600 U/min
(50%)
51 min
1.65 kWh
*
Programme setting for testing in accordance with applicable standard EN61121.
** The values may differ from those specified, depending on the type of fabric, composition of
laundry to be dried, residual moisture in the fabric and the amount of laundry being loaded.
Fabrics/programmes
Drying time
Annual energy consumption
Cottons 7 kg / 3.5 kg*
Cupboard Dry***
97 min / per cycle
504 kWh / per year
***Programme setting for testing and energy labelling in accordance with Directive 2010/30/EU.
Optional accessories
(from after-sales service using order number)
Washer-dryer stack connection set
The dryer can be placed on top of a suitable washing machine with the same width and depth
to save space. The dryer must be fastened to the washing machine using this connection set.
Connection fittings for condensation outlet
The condensation is conveyed directly via a hose.
Installation underneath the worktop
Instead of the appliance covering plate, you must have a metal cover fitted by
a specialist.
CZ
11390
WZ
20160
WZ
20290
ʠ
ʠ
a
ʠ
ā
a
ʠ
4
a
a
ʠ
u
a
a
ʠ
ʠ
ʠ
ʠ
ʠ
a
ʠ
a
a
a
a
ʠ
a
a
a
a
a
ʠ
ʠ
a
a
ʠ
a
a
a
a
a
a
a
a
a
a