Neff R8580X1GB - Manual (Page 4)

3 4
' ˎ ч ч
ˎ
Icc+cc\
a
a
4
.
u
ˎ
ˎ
ogramme selected, e.g. 1:54h a 2h; 1 -24 hrs
3 quiet), 2 (normal), 3 (loud), 4 (very loud). 0, 1, 2, 3, 4
# On-Off
9 ed over three levels (1 - max. 3) for the
a
ted, the setting is retained for the others.
0, 1, 2, 3
600-1800 ²
... and adapt to individual requirements
Inspecting
the dryer
Sorting and loading laundry
a Page 8.
See also separate instructions for “basket for woollens”
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
Selecting and adjusting the programme
Select the drying programme ...
Press the Start/Stop button
Connecting the
mains plug
All buttons are sensitive,
a light touch is enough!
3
2
1
Drying / Short spin /
Refresh
Drying Emptying condensation
Empty the container after each drying cycle, not during drying!
1. Remove the container, holding it level.
2. Pour out condensation.
3. Push the . container back in until it clicks into place.
Cleaning the fluff filter
1. Open the door, remove the filter and fold open.
2. Remove the fluff (by wiping the filter with your hand).
3. Close the filter, insert it again and close the door.
4. Remove fluff from the door and the area around it.
Very dirty or blocked filters should be rinsed under warm
water, and then dried thoroughly.
Clean the filter in the water tank
if it is dirty
1. Remove the condensation tank.
2. Remove the filter.
3. Clean the filter under running water.
4. Re-insert the filter and push in the condensation tank until it clicks into
place.
Switching off the dryer
Turn the programme selector to Off.
Do not leave damp laundry in the dryer.
Removing the laundry
The automatic Easy Iron function moves the drum at certain intervals. The load remains loose and soft for
an hour (or two hours if you manually select the Less Ironing function, depending on the model.)
(
'c
a cч ч
)c
a
a
a
a
a
a
a
a
a
a
a
a
a
Condensation container
Control panel
Air inlet
Fluff filter
Drum
4
Cover for
steam nozzle
Air cooler
Programme end
once \ lights up in the display.
Interrupt programme
removing or adding laundry.
The drying cycle can be interrupted for a brief period so that laundry may be added or removed.
The selected programme must then be continued until it is finished.
Hot steam may escape during the Steam Drying / Steam Refresh programmes.
1. Open the door. The drying cycle is paused.
2. Remove or add laundry and close the door.
3. If required, select a new programme and additional functions.
4. Press the Start/Stop button. The remaining time is updated after a few minutes.
Water tank
filling hole
with filter
ʋ
ʋ
c
@
c
c
c
÷@
c
@ @
a a
a