Brother P-touch PT-1750 - Manual (Page 35)

33
CUTTER ERROR! This message appears if the
tape cutter lever is pressed
down while a label is being
printed. Release the tape cutter lever.
INVAL. CHRS! This message appears if the
cursor is not below a number
when you hold down
f and
press
A.
Move the cursor below a
number before holding down
f and press A.
LINE LIMIT! This message appears if the
number of lines in the text is
greater than the maximum
number of lines possible for
the installed tape. Reduce the number of lines
or install a tape of greater
width.
MEMORY FULL! This message appears if you try
to store a text file after 300
characters have already been
stored in the memory. Delete an unwanted file to
make room for the new one.
NO FILES! This message appears if you try
to recall or delete a text file
from the memory when none
are stored. Store a text file first.
NO TAPE! This message appears if you try
to print a label or feed the tape
when no tape cassette is
installed. Install a tape cassette and try
again.
TOO SMALL! This message appears if the
number that is set to be printed
using the Numbering function
is less than the number above
the cursor. Press the key of a number
that is greater than the
number in the text.
Error Message Cause Remedy