Sharp R-82STW Four à micro-ondes combiné - Manual (Page 170)

GB-8
BEFORE OPERATION
MICROWAVE POWER LEVELS
Plug in the oven. The oven display will display: “0:00”, an audible signal will sound once.
This model has a clock function and the oven uses less than 1.0 W in stand by mode. To set the clock, see below.
SETTING THE CLOCK
There are two setting modes: 12 hour clock and 24 hour clock.
1. To set the 24 hour clock, press the CLOCK SET/ DELAY START button (
) once and “24H” will appear in
the display. To set the 12 hour clock, press the CLOCK SET/DELAY START button ( ) once more and “12H”
will appear in the display.
2. Rotate the ENTRY dial until the correct hour is displayed, the input time should be within 0-23 (24-hour
clock) or 1 -12 (12-hour clock).
3. Press the CLOCK SET/ DELAY START button ( ), the minute fi gure will fl ash.
4. Set the minutes. Rotate the ENTRY dial until the correct minutes are displayed, the input time should be
within 0-59.
5. Press the CLOCK SET/ DELAY START button ( ) once to start the clock. The icon “:” of the digital time
will be fl ashing on the display.
NOTES:
• If the clock is set, when cooking is complete, the display will show the correct time of day. If the clock has not
been set, the display will show "0:00".
• To check the time of day during a cooking process, press CLOCK SET/DELAY START button ( ) and the
LED will display the time of day for 2-3 seconds. This does not aff ect the cooking process.
• In the process of clock setting, if the STOP button is pressed, the oven will go back to the former setting.
• If the electrical power supply to your microwave oven is interrupted, the display will intermittently show "0:00" after the
power is reinstated. If this occurs during cooking, the programme will be erased. The time of day will also be erased.
Power Level Press the
MICROWAVE POWER
LEVEL button
Display
(Percentage)
• Your oven has 5 power levels, as shown.
• To change the power level for cooking, press the MICROWAVE
POWER LEVEL button or rotate the ENTRY dial key until
the display indicates the desired level. Press the START/+30sec/
CONFIRM button (
) to confirm, enter the cook-
ing time and then press the START/+30sec/ CONFIRM button
(
) to start the oven.
• To check the power level during cooking, press the MICROWAVE
POWER LEVEL button . The current power level will be
displayed for 2-3 seconds. The oven continues to count down
although the display will show the power level.
HIGH x1 P100
(100%)
MEDIUM
HIGH x2 P80
(80%)
MEDIUM x3 P50
(50%)
MEDIUM LOW
(DEFROST) x4 P30
(30%)
LOW x5 P10
(10%)
Generally the following recommendations apply:
P100 - (HIGH output = 900W) used for fast cooking or reheating e.g.
for casseroles, hot beverages, vegetables etc.
P80 - (MEDIUM HIGH output = 720W) used for longer cooking of
dense foods such as roast joints, meat loaf and plated meals, also for
sensitive dishes such as sponge cakes. At this reduced setting, the
food will cook evenly without over cooking at the sides.
P50 - (MEDIUM output = 450W) for dense foods which require a long
cooking time when cooked conventionally, e.g. beef casserole, it is
advisable to use this power setting to ensure the meat will be tender. P30 - (MEDIUM LOW output = 270 W Defrost setting) to defrost, select
this power setting, to ensure that the dish defrosts evenly. This setting is
also ideal for simmering rice, pasta, dumplings and cooking egg custard.
P10 - (LOW output = 90 W) for gentle defrosting, e.g. cream gateaux or
pastry.
R-82ST_OM_WEST.indb Sek1:8 R-82ST_OM_WEST.indb Sek1:8 2012-06-27 01:09:17 2012-06-27 01:09:17