Beko WMXD 760 S - Manual (Page 19)

EN 19
Auxiliary functions
Auxiliary Function Selection Buttons
Select the required auxiliary functions
before starting the program.
C Some combinations cannot be
selected together.
Auxiliary function selection
If an auxiliary function that should not
be selected together with a previously
selected function is chosen, the first
selected function will be cancelled and
the last auxiliary function selection will
remain active.
(Ex.: If you want to select pre-wash first
and then quick wash, Pre-wash will be
cancelled and Quick wash will remain
active.
Auxiliary function that is not compatible
with the program cannot be selected.
(See, “Program Selection Table”)
C Auxiliary function buttons may differ
according to the model of your
machine.
Pre-wash
A pre-wash is only worthwhile for heavily
soiled laundry. Without pre-wash you
save energy, water, detergent and time.
C Pre-wash without detergent is
recommended for lace and curtains.
Quick wash
This function can be used for “Cottons”
and “Synthetics” programs. It decreases
the washing times for lightly soiled
laundries and also the number of rinsing
steps.
Extra rinse
This function allows your machine to
perform an extra rinsing in addition to
the rinsing cycles performed by your
machine after main washing cycle.
Thus, the risk for sensitive skins (babies,
allergic skins and etc.) to be effected by
the minimal detergent remnants on the
laundry is reduced.
Anti-creasing
With this function, drum movement will
be lessened to prevent creasing and
spinning speed is limited. In addition,
washing is carried out at a higher water
level.
C Use this function for delicate
laundries that crease easily.
C Whenever you select this auxiliary
function, load your machine with half
of the maximum laundry specified in
the program table.
Time display
The display shows the time remaining
for the program to complete while a
program is running. Time is displayed in
hours and minutes as “01:30”.
C Program duration may differ from
the values in the consumption
table subject to the changes in the
water pressure, water hardness and
temperature, ambient temperature,
type and amount of laundry, auxiliary
functions selected, and changes in
the supply voltage.
Time delay
With the “Time delay” function you can
delay the program start up to 24 hours.
Time delay can be increased in half hour
increments.
C Do not use liquid detergent when
you set time delay! There is the risk
of staining of the clothes.
1. Open the door, place the laundry
inside and fill detergent drawer.
2. Set the washing program, spin
speed and, if required, select the
auxiliary functions.
3. Press “Time Delay” buttons to adjust
the desired time.
4. Press Start/Pause/Cancel button.
The time delay will start to count
down. The “:” in the middle of the
displayed time delay will start to
flash.
C More laundry may be loaded during
the time delay period.
5. At the end of the time delay count
down, “:” will light up continuously
and the relevant program follow-up