Bunn CDBC TWIN - Manual (Page 5)

Page 5
ON/OFF SWITCH
Placing the "ON/OFF" switch in the "ON" upper position supplies power to the brew station warmer, enables the
brew circuit, and energizes the tank refill circuit. Placing the switch in the "OFF" lower position stops tank refilling,
brewing and deenergizes the brew station warmer. Stopping a brew cycle after it has been started will not stop the
flow of water into the decanter until the funnel is empty.
NOTE – Hot water will be available at the faucet in a limited amount when the switch is in the "OFF" position because
the tank will not refill.
BREW SWITCH
Momentarily pressing and releasing the switch starts a brew cycle when the "ON/OFF" switch is in the "ON" upper
position.
NOTE – The "ON/OFF" switch must be in the "ON" upper position to initiate and complete a brew cycle.
ADDITIONAL WARMER SWITCHES
Placing any additional warmer switch in the "ON" upper position supplies power to the associated warmer.
READY INDICATOR
This indicator glows when the preselected brew water temperature has been achieved.
OPERATING CONTROLS
Model CEZ TWIN
ON/OFF BREW FRONT-SIDE-REAR ON/OFF BREW FRONT-SIDE-REAR