Briggs & Stratton 8 - Manual (Page 24)

24
H. Turn off Machine and Hand-Held Wired Remote Controller.
I. Disconnect electronics and stow controllers in bin below Electronic Machine
Controller (Figure 30).
J. Pull locking pin and secure in hole below latch for transport.
K. Release jacks by turning crank. Wind jack up to approximately 3 inches
(76.2 mm) above surface and rotate jack 90 degrees on its mount. Secure
with pin for transport.
L. Connect trailer to tow vehicle (if previously disconnected).
Service & Maintenance
A. Follow Briggs and Stratton Owners Manual for engine maintenance (the engine
oil drain is located beneath the trailer).
B. Inspect tires (LT 225/75R16) for proper wear and always keep inflated to the
specification denoted on the sidewall of the tire.
C. Inspect lighting and replace bulbs as required.
D. Maintain the hydraulic fluid with auto transmission fluid (Mercon/Dexron III) at
least three quarter tank.
E. Replace filters and auto transmission fluid when it turns brown color or after
500 hours of operation (the reservoir drain is located beneath the trailer).
Troubleshooting Guide
11.
Problem
Drum moving in the wrong direction
while loading and unloading after the
machine was shut down.
Drum is moving faster or slower than
the arms.
Machine will not run after pressing
load button or the load button LED
kept turning off after pushing it.
Load LED is flashing after pressed.
Solution
Move the drum towards engine using
transport drum button or move it
towards the arms using the load drum
button to guide the controller in the
correct direction of the drum.
The drum speed can be adjusted
using ‘+’ or ‘-’ button depending on the
drum direction and speed.
Check the Access Doors if they are
closed and Tilt Panels are tilted.
Turn Load Dial completely
counterclockwise (to zero) and press
button again.
10.