Beko BD-300 User Manual
Page 13
4. Press UP/DOWN button to change the volume
5. Press the OK button to confirm the volume level you chosen
Least cost route (LCR) function (Optional)
With the LCR function, the phone will automatically replace a long number (up to 11 digits)
with a comparative short number (up to 3 digits), to simplify the process of dialing a long
number.
Example:
If you program to replace "00" with "17909", whenever you dial a number beginning with
the“00”, the phone will automatically change this to “17909”. If he dials "00 15151500", the
phone will automatically replace
the number to be dialed out as “17909 15151500”
Note:
LCR function only replace the prefix of the phone number you dial.
To set LCR:
1. Press MENU button then UP/DOWN button to the location BASE SET
2. Press the OK button, the display shows PIN?
3. Key in your PIN number and press the OK button, then UP/DOWN button to the
location LCR
4. Press the OK button, the display shows SHORT?
5. Press the OK button, the display shows EMPTY, key in the short number you want to
replace the long number directly
6. Press the OK button to confirm, then the display shows LONG?
7. Press the OK button, the display shows EMPTY, key in the long number
8. Press the OK button to confirm
To Set Dial Mode
You can change dial mode to TONE or PULSE dialing.
To set dial mode:
1. Press MENU button, then UP/DOWN button to the location BASE SET
2. Press the OK button, the display shows PIN?
3. Key in your PIN number and press the OK button, then press UP/DOWN button to
the location DIAL MODE
4. Press the OK button and press UP/DOWN button to change Dial mode as TONE or
PULSE dialing
To reset base
1. Press MENU button, then UP/DOWN button to the location BASE SET
2. Press the OK button, the display shows PIN?
3. Key in your PIN number and press the OK button, then UP/DOWN button to the
location B RESET
4. Press OK button, then the display shows RESET?
5. Press OK button to confirm, or Press CLEAR button, and go back to B RESET
To change base PIN
1. Press MENU button, then UP/DOWN button to the location BASE SET