Toshiba Satellite L10 - Manual (Page 146)

User’s Manual B-8
Display Controller and Modes
2. In some cases DVD video playback images may not be displayed when
the display of the computer and a CRT display are used at the same.
Reduce the resolution, use the display of the computer only, use the
CRT display only or set display device in the multi-monitor, then play
DVD.
■ Please refer to External monitor in Chapter 7, Optional Devices , or
the application guide for the setting of each display device.
3. The DVD video overlay is not displayed when the display mode of CRT
display is set to high resolution and high refresh rate mode.
Please decrease the resolution and refresh rate of CRT display.
4. When the display mode is TV or simultaneous LCD (internal liquid
crystal display)/TV and the system goes into Standby or Hibernation
Mode, you can switch to the LCD (internal liquid crystal display) display
mode by pressing Fn + F5. Under this environment, however, you may
not return to the TV or simultaneous LCD (internal liquid crystal
display)/TV display mode.
In these cases, perform the following steps:
Press Ctrl + Alt + F12 to select Intel(R) 82852/82855 GM/GME
Graphics Controller Prope.... Then click the icon indicating a display
device (display mode) you want to use in the left pane of the Devices
tab.
5. When the LCD (internal liquid crystal display) display mode is selected,
the Virtual (Virtual Screen) display mode can be set. However,
afterwards, it may not possible to change the screen resolution to more
than 1280 x 1024 pixels in Highest (32bit) mode (for example, when you
attempt to set the resolution to 1600 x 1200 using the Screen resolution
slide bar and then select Highest (32bit) mode from the Color quality
drop-down menu).
In these cases, perform the steps below:
First, use the Screen resolution slide bar to select the 1024 x 768
resolution, and then change the resolution to more than 1280 x 1024
and select Highest (32bit) from the Color quality drop-down menu.