beautypg.com

Set up the hyperterminal with usb to serial port – Toshiba USB Port Replicator II User Manual

Page 21

background image

- 21-

Set up the HyperTerminal with USB to serial port

Follow the steps below to configure your HyperTerminal with USB to serial COM
port setting:

1. Make sure that HyperTerminal is installed in your system. If not, please click

Start, Settings, Control Panel, double click Add/Remove Programs, choose
Windows Setup page, Communications, click Details button, enable
HyperTerminal to install the program to your Windows system.

2. Please click on Start, Settings, Control Panel, double click System, and click on

Device Manager. Check which COM port is located by USB to serial port.

3. If you have setup HyperTerminal before, please run Start, Programs,

Accessories, Communications, HyperTerminal, HyperTrm.exe. Click File,
Properties. The Properties dialog page will appear on your screen. If you are first
time to setup HyperTerminal, you will see this page during the setup procedure.