Toshiba Equium L20 - Manual (Page 85)

User’s Manual 4-17
Operating Basics
InterVideo WinDVD Creator Platinum
Please refer to the on-line Help for additional InterVideo WinDVD Creator
information.
When writing the Setup files for the program into a disc formatted by DLA
and starting Setup from this disc, an error may occur. In this case, plase
copy them to your hard disk and then run Setup.
Note the following limitations when you write video DVD:
1. Editing digital video
■ Log in with Administrator rights to use WinDVD Creator.
■ Make sure that your computer is running on AC power when using
WinDVD Creator.
■ Operate the computer under the power scheme Always ON.
Do not use power-saving features.
■ While you are editing DVD, you can display previews. However,
if another application is running, the preview might not display
properly.
■ WinDVD Creator cannot show video on the external monitor when in
simultaneous mode.
■ WinDVD Creator cannot edit or play copy protected content.
■ Do not change display settings while using WinDVD Creator.
■ Do not enter standby/hibernation mode while using WinDVD
Creator.
■ Do not operate WinDVD Creator immediately after turning on the
computer. Please wait until all Disc Drive activity has stopped.
■ When recording to a DV-Camcorder, to ensure you capture all of
your data, let the camcorder record for a few seconds before you
begin recording your actual data.
■ CD recorder, JPEG functions, DVD-Audio, mini DVD and Video CD
functions are not supported in this version.
■ While recording video to DVD or tape, please close all other
programs.
■ Do not run software like a screen saver because it can put a heavy
load on the CPU.
■ Do not run communication applications like a modem or a LAN.