Toshiba Equium A80 - Manual (Page 128)

Toshiba A80 7-3
HW Setup
CPU
This function lets you set the CPU operating mode.
Dynamic CPU Frequency Mode
This option lets you choose from the following settings:
Boot Priority
Boot Priority Options
This option sets the priority for booting the computer.
You can override the settings and manually select a boot device by pressing
one of the following keys while the computer is booting:
FDD is looked for when the boot disk is contained in external hard disk drive.
To change the boot drive, follow the steps below.
1. Hold down F12 and boot the computer.
2. The boot select screen will be displayed: HDD, CD/DVD, FDD, and LAN.
3. Use the cursor keys to highlight the boot device you want and press
Enter.
Hard Disk Drive Priority Options
If more than one hard disk drive is installed in the computer, this option lets
you set the priority for hard disk drive detection. If the first detected hard disk
drive has a boot command, the system will boot from the hard disk drive.
It is displayed in Pentium-M model only.
Dynamically
Switchable
CPU power consumption and clock speed
automatic switching function is enabled. When the
computer is in use, CPU operation is automatically
switched when necessary (Default).
Always Low CPU power consumption and clock speed
automatic switching function is disabled. The CPU
always runs at low power consumption and low
speed.
U Selects the USB floppy disk drive.
N Selects the Network.
C Selects optical device.
Built-in HDD ->
2nd HDD The computer will look for the Built-in hard disk
drive first, next the 2nd hard disk drive and then
the hard disk drive (Default).