Bissell 3108 User Manual

Page 6

Power cord quick release

Remove the plastic plug guard and dispose.

Unclip polarized plug from power cord.

Rotate the upper cord wrap towards floor
and slip power cord from upper and lower
cord wraps.

Connect power cord plug to a polarized outlet.

To keep the power cord out of your way
while cleaning, place it in the cord hook at
the top/back of the handle.

Power switch

The power switch is located just above the
canister handle. Use one of three settings.

Bare Floor - use this setting to turn off the rotating

PowerBrush if desired for bare floors

Carpet PowerBrush- use this setting to turn on the

rotating PowerBrush for carpeted surfaces

Off - Turn off the vacuum when cleaning is

complete

Cleaning with the canister

Your BISSELL Easy Vac is not only a convenient
upright bare floor and carpet cleaner, it's also a
versatile floor/above floor vacuum cleaner when
you detach the lightweight canister.

1. Detach the upright handle by pressing your

thumb and forefinger on the lock buttons on
canister (using a "pinching" motion) while
gently pulling handle off square end of canister.

2. For above floor surfaces or stairs, use the

floor nozzle following the directions for the
power switch settings.

3. For edge or small area cleaning, remove the

floor nozzle and unplug from the canister.
You can then use the canister directly or
place the crevice tool in the round opening
for added versatility.

4. To resume upright cleaning, reattach the floor

nozzle and plug into the back of the canister.

perations

w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1

Lower Cord Wrap

Upper Cord Wrap

Tip:

Before cleaning

under low furniture,
check for objects
that might block the
vacuum hose. Do
not pick up hard
or sharp objects
such as glass,
nails, screws, coins,
paper clips, etc.

ug010-0136_3108-8_706.indd 6

7/27/06 4:37:33 PM