beautypg.com

Black & Decker SDC740 User Manual

Page 4

background image

6

5

STANDARD INSTALLATION (FLAT CABINET)
Important: Always wear protective glasses or goggles to prevent injury when

drilling.
1. Clear countertop under installation area to avoid getting dust or debris on other

appliances or items. Open cabinets and remove contents to make mounting

easier.

2. With cabinet doors open, place mounting template flush against the surface of

the underside of your cabinet, making sure to align thick line on template with

bottom front edge of your cabinet

(D).

Important: Do not align screw holes on template with the partition between

cabinets, as this will prevent you from installing the appliance properly. Pay

close attention to where the drill holes will be set so as not to damage your

cabinets during mounting. Drilling through your cabinet’s partition may cause

damage to cabinets and prevent proper installation.
3. Once thick line is straight with bottom front edge, pull template tight and tape

down on all 4 corners to hold in place.

4. Drilling from under the cabinet up, drill holes through the 4 places marked on

the template, using a ¼-inch drill bit

(E).

Important: Always ensure you are drilling straight up through the marked

mounting hole on the template. Drilling at an angle may prevent proper

installation and may damage cabinets if the drill bit pierces the partition.
5. Once holes are drilled, remove tape and mounting template and save template

with your instructions in case you move or wish to remount at a later time.

6. Wipe dust and debris off inside cabinet surface. Also, make sure under-side of

cabinet is clean.

7. Place a washer inside the cabinet over each of the 4 holes you drilled.

D

E

GETTING STARTED
• Remove all packing material, labels and any stickers.
• Remove and save literature.
• Unpack mounting washers, screws and spacers for mounting and set them

aside in a safe place where they will not roll away or get lost.

Important: Do not attempt to operate appliance until it is properly installed.
CHOOSE A LOCATION
When choosing your location, consider the following:

DO make sure to mount within reach of an electrical outlet.

DO consider your normal work patterns in the kitchen when choosing

location.

DO NOT mount over any heating or cooking appliance such as your range or

oven.

DO NOT mount over or near a sink.

DO NOT mount under, in front of or behind any under-cabinet light fixtures.

Note: If you are mounting multiple †SpaceMaker™ appliances, they should not

be mounted flush to one another. Allow at least 4” of space between appliances

for adequate cooling.
Caution: This appliance features a Save-A-Plug™ outlet receptacle to connect

smaller †SpaceMaker™ appliances such as the mini food processor / grinder or

can opener. Do not use this outlet for any other appliance!
Caution: When selecting a location for your coffeemaker, make sure you have

adequate room to reach the Rear Receptacle.
Note:
If you are connecting another †SpaceMaker appliance into the Save-A-

Plug™ outlet, make sure you can easily unplug the appliance after each use.
DETERMINE CABINET TYPE
Prior to taping the mounting template and beginning to drill your holes, determine

if your cabinet has a flat bottom

(B) or an overhanging lip (C). If your cabinet is

flat, follow STANDARD INSTALLATION; if the cabinet has a lip, refer to SPACER

MOUNTING INSTALLATION.

B

C

This manual is related to the following products: