Pioneer AVH-X8600BT - Manual (Page 8)

< CRD4782-A >8
8
Engb
Places exposed to direct sunlight, such
as on top of the dashboard.
Places that may be exposed to rain, such
as close to the door or on the vehicle’s
floor.
Install this product horizontally on a
surface within 0 to 30 degrees tolerance
(within 5 degrees to the left or right).
Improper installation of the unit with
the surface tilted more than these toler-
ances increases the potential for errors
in the vehicle’s location display, and
might otherwise cause reduced display
performance.
30°
When installing, to ensure proper heat
dispersal when using this unit, make sure
you leave ample space behind the rear
panel and wrap any loose cables so they
are not blocking the vents.
Leave ample
space
5 cm
5 cm
■ Before installing this product
1 Remove the trim ring.
Extend top and bottom of the trim ring
outwards to remove the trim ring.
1
1 Trim ring
2 Insert the supplied extraction keys
into both sides of the unit until
they click into place.
3 Pull the unit out of the holder.
1
1 Extraction key
■ Installation with the holder
1 Install the holder into the
dashboard.
2 Secure the mounting sleeve by
using a screwdriver to bend the
metal tabs (90°) into place.
1
2
1 Dashboard
2 Holder
3 Install this product into the holder.
1
1 Dashboard
4 Attach the trim ring.
1
2
1 Trim ring
2 Groove
Attach the trim ring with the side with a
groove facing downward.
■ Installation using the screw
holes on the side of this product
Fastening this product to the fac-
tory radio-mounting bracket.
Position this product so that its screw holes
are aligned with the screw holes of the
bracket, and tighten the screws at three
locations on each side.
Use either the truss head screws (5 mm
× 8 mm) or flush surface screws (5 mm
× 9 mm), depending on the shape of the
bracket’s screw holes.
If the pawl interferes with installation,
you may bend it down out of the way.
1
2
3
1 Factory radio-mounting bracket
2 Dashboard or console
3 Truss head screw or flush surface screw
Be sure to use the screws supplied with
this product.
Installing the microphone
Install the microphone in a place where
its direction and distance from the driver
make it easiest to pick up the driver’s
voice.
Be sure to turn off (ACC OFF) the product
before connecting the microphone.