Pioneer PDP-S41 - Manual (Page 3)

3
English
English
INSTALLATION ON THE PLASMA
DISPLAY
Perform installation according to the following steps 1 to 4.
NOTE:
Before attaching the speaker, please attach the table top
stand to the Plasma Display unit.
1. Attach the speaker mounting fittings to the
rear of the Plasma Display.
• Attach the fittings for right and left sides to the bottom
right and left on the rear panel of the Plasma Display using
the supplied screws.
• Tighten the two screws in the order 1 followed by 2.
Plasma Display with the speaker installed
Speaker
mounting
screw
(M5 x 10 mm)
Speaker mounting fitting
(right side)
Speaker cable
Speaker mounting
fitting (center)
Speaker
Speaker mounting
fitting (left side)
Speaker
mounting screw
(M5 x 10 mm)
2. Attach the center fitting to the lower center
on the rear panel of the Plasma Display.
• Attach the center fitting to the lower center on the rear
panel of the Plasma Display using the four supplied
screws.
• Tighten the four screws in the order 1, 2, 3, 4 as shown
in the drawing.
• When fitting the screws, place screws 1 and 2 through
the holes in the center fitting, and align screws 3 and 4
with the cutaway slots in the center fitting.
NOTE:
• See page 6 for speaker mounting procedures when using
the hung on wall unit.
Speaker mounting
screw (M5 x 10 mm)
Bead Band
(Accessories of the Plasma Display)
1
2
Speaker mounting
screw (M5 x 10 mm)
Label “L” is
affixed to the left
side fitting.
(Similarly, label
“R” is
affixed to the
right side fitting.)
Speaker mounting fitting for the
left side
(the fitting method is the same
as the fitting for the right side)
1
2
3
4
Speaker mounting
screw (M5 x 10 mm)
Speaker mounting fitting for
center