Pioneer SE DIR800C - Manual (Page 18)

02 Getting started
18
En
Connecting the transmitter to analog sources
Use a commercially available stereo audio cable with RCA/pin plugs to connect the audio
output jacks of a VCR, TV or other component to the LINE IN (L/R) jacks on the transmitter.
For equipment that has only a mini jack headphone output, such as a personal CD player, use
a commercially available stereo mini plug to RCA/pin plug x 2 cable. Note that the signal may
be noisy if the volume on the player is set too low.
Setting the input level
Set the ATT (attenuator) switch to 0dB if the volume is low using analog input.
Transmitter
To LINE IN jacks
Stereo audio cable (sold separately)
Left (L, white)
Right (R, red)
Left (L, white)
Right (R, red)
To audio output jacks
VCR, TV, etc.
LINE ATT
Setting Components connected
0dB TV, portable players and
others with a low output level
-8dB Other components (initial setting)
Note
! Be sure to lower the volume before
setting the ATT switch.
Set the ATT switch to -8dB if audio input
to the LINE INPUT jacks is distorted
(sometimes noise can be heard at the
same time).