Bravo View IND-5000BT - Manual (Page 13)

12
Radio Mode
Accessing Radio Mode
Press the SRC button on the front panel or
remote control to switch to the Radio source.
1. Source Indicator
2. Current Preset Channels
3. Time/Clock
4. AM/FM Band
5. Radio Station Frequency
6. EQ Indicator
Selecting a Band
Press BAND once or more to select FM1-
FM2 - FM3 - AM1 - AM2.
Display shows wave band, frequency, and
preset station number if already stored.
Selecting a Station
Press the or tuning button to tune to
another station.
Tuning
- AUTO SEEK
Press the or buttons to seek the next/
previous station automatically.
- MANUAL SEEK
Press and hold the or buttons to enter
manual tuning mode. Press the buttons again
to move the radio frequency number up or
down one step.
Note:
During manual seeking, if the pause between
two operating steps is longer than 5 seconds,
press the
or buttons, the unit will enter
auto seeking.
Preset Mode
Six numbered preset buttons store and recall
stations for each band. The stored stations
(P1-P6) for the current band can be viewed on
the screen.
Storing Stations
- Auto storing
1. Select a band (if needed).
2. Press AMS briefly to scan the preset station
P1 - P6 for 5 seconds each.
3. Hold AMS more than 2 seconds, the
6 strongest available stations will be
automatically saved in the preset button
(numbers 1-6).
- Manual Storing
1. Select a band (if needed), then select a
station.
2. Press and hold a preset button (numbers
1-6) on the front panel or remote control.
3. The preset number and station is displayed
and highlighted.
Recalling a Station
1. Select a band (if needed).
2. Press a front panel or remote control
preset button (numbers 1-6) to select the
corresponding stored station.
2 1 3
4
5
6