Pioneer M-10X - Manual (Page 4)

4
En
LOCATION
Install the unit in a well-ventilated location where
it will not be exposed to high temperatures or
humidity.
Do not install the unit in a location which is exposed to
direct rays of the sun, or near hot appliances or radia-
tors. Excessive heat can adversely affect the cabinet and
internal components. Installation of the unit in a damp
or dusty environment may also result in a malfunction
or an accident. (Avoid installation near cookers etc.,
where the unit may be exposed to oily smoke, steam or
heat.)
Do not install the unit on a tottered stand, nor on an
unstable or inclined surface.
VENTILATION
• When installing this unit, make sure to leave space
around the unit for ventilation to improve heat ra-
diation (at least 55 cm (22 in.) at top, 10 cm (4 in.) at
rear, and 20 cm (8 in.) at each side). If not enough
space is provided between the unit and walls or other
equipment, heat will build up inside, interfering with
performance or causing malfunctions.
• Do not place on a thick carpet, bed, sofa or fabric
having a thick pile. Do not cover with fabric or other
covering.
Anything that blocks ventilation will cause internal
temperature to rise, which may lead to breakdown
or fire hazard.
CONDENSATION
When the unit is brought into a warm room from previ-
ously cold conditions or when the room temperature is
suddenly increased, condensation may form inside and
the unit may not be able to attain its full performance. In
cases like this, allow the unit to stand for about an hour
or raise the room temperature gradually.
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull out the
plug by tugging the cord and never touch the power
cord when your hands are wet as this could cause a
short circuit or electric shock. Do not place the unit, a
piece of furniture, etc., on the power cord, or pinch the
cord. Never make a knot in the cord or tie it with other
cords. The power cords should be routed such that they
are not likely to be stepped on. A damaged power cord
can cause a fire or give you an electrical shock. Check
the power cord once in a while. When you find it dam-
aged, ask your nearest PIONEER authorized service cen-
ter or your dealer for a replacement.
NOTES:
• If you use an other power cord than provided, we cannot assume the
liabilities in what may occur as a result of it.
• (The provided power cord has a current capacity of 7 A.)
INSTALLATION
NOTE IMPORTANTE SUR LE
CABLE D’ALIMENTATION
Tenir le câble d’alimentation par la fiche. Ne pas
débrancher la prise en tirant sur le câble et ne pas
toucher le câble avec les mains mouillées. Cela risque de
provoquer un court-circuit ou un choc électrique. Ne pas
poser l’appareil ou un meuble sur le câble. Ne pas pincer
le câble. Ne pas faire de noeud avec le câble ou
l’attacher à d’autres câbles. Les câbles d’alimentation
doivent être posés de façon à ne pas être écrasés. Un
câble abîmé peut provoquer un risque d’incendie ou un
choc électrique. Vérifier le câble d’alimentation de temps
en temps. Contacter le service après-vente PIONEER le
plus proche ou le revendeur pour un remplacement.