Adjusting the lcd panel angle, Turning the lcd panel horizontal, Changing the wide screen mode – Pioneer AVIC-X1R User Manual
Page 17
15
Ch
ap
te
r
1
H
ow
to
U
se Na
vig
ati
o
n
U
n
it a
n
d
Na
m
es
o
f t
h
e Pa
rts
Adjusting the LCD panel angle
Important:
• If you can hear the LCD panel knocking against
your vehicle’s console or dashboard, press
ANGLE (–) button to move the LCD panel a
little forward.
• When adjusting the LCD panel angle, be sure
to press ANGLE (+/–) button. Forcibly
adjusting the LCD panel by hand may damage
it.
• Press ANGLE (+/–) button to adjust the
LCD panel to an easily viewable angle.
The LCD panel angle continues changing as
long as you press ANGLE (+/–) button and
hold.
❒
The adjusted the LCD panel angle will be
memorised and the LCD panel will
automatically return to this angle the next
time the LCD panel is opened.
Turning the LCD panel
horizontal
When the LCD panel is upright and it hinders the
operation of the air conditioner, the position of
the panel can be turned horizontal temporarily.
• Press FLIP DOWN/CLOCK button to turn
the LCD panel horizontal.
❒
To return to original position, press FLIP
DOWN/CLOCK button again.
❒
The LCD panel returns to the original
position automatically with beep sounds
10 seconds after operation.
Changing the wide screen mode
• Press WIDE button to select the desired
setting.
Press WIDE button repeatedly to switch
between the following settings:
FULL (full) – JUST (just) – CINEMA
(cinema) – ZOOM (zoom) – NORMAL
(normal)
FULL (full)
A 4:3 picture is enlarged in the horizontal
direction only, enabling you to enjoy a 4:3 TV
picture (normal picture) without any omissions.
JUST (just)
The picture is enlarged slightly at the centre and
the amount of enlargement increases
horizontally toward the ends of the picture,
enabling you to enjoy a 4:3 picture without
sensing any disparity even on a wide screen.
CINEMA (cinema)
A picture is enlarged by the same proportion as
FULL or ZOOM in the horizontal direction and
by an intermediate proportion between FULL and
ZOOM in the vertical direction; ideal for a
cinema-sized picture (wide screen picture) where
captions lie outside.
ZOOM (zoom)
A 4:3 picture is enlarged in the same proportion
both vertically and horizontally; ideal for a
cinema-sized picture (wide screen picture).
NORMAL (normal)
A 4:3 picture is displayed as it is, giving you no
sense of disparity since its proportions are the
same as that of the normal picture.
❒
Different settings can be memorised for each
video source.
❒
When video is viewed in a wide screen mode
that does not match its original aspect ratio, it
may appear differently.
❒
Remember that use of this system for
commercial or public viewing purposes may
constitute an infringement on the author’s
rights protected by the Copyright Law.
❒
Video will appear grainy when viewed in
CINEMA or ZOOM mode.
MAN-AVIC-X1R-EN.book Page 15 Wednesday, May 4, 2005 4:45 PM