Pioneer DEH-8400BT - Manual (Page 18)

1 Press and hold to display the con-
nection menu.
# You cannot operate this step during a call.
2 Turn M.C. to select the function.
After selecting, perform the following proce-
dures to set the function.
Device list (connecting or disconnecting a device
from the device list)
! When no device is selected in the device list, this
function is not available.
1 Press M.C. to display the setting mode.
2 Turn M.C. to select the name of a device you want
to connect/disconnect.
! Press and hold M.C. to switch the Bluetooth
device address and device name.
3 Press M.C. to connect/disconnect the selected de-
vice.
Once the connection is established,
Connected
is displayed.
Delete device (deleting a device from the device list)
! When no device is selected in the device list, this
function is not available.
1 Press M.C. to display the setting mode.
2 Turn M.C. to select the name of a device you want
to delete.
! Press and hold M.C. to switch the Bluetooth
device address and device name.
3 Press M.C. to display Delete YES.
4 Press M.C. to delete a device information from
the device list.
! While this function is in use, do not turn off the
engine.
Add device (connecting a new device)
1 Press M.C. to start searching.
! To cancel, press M.C. while searching.
! If this unit fails to find any available cellular
phones, Not found is displayed.
2 Turn M.C. to select a device from the device list.
! Press and hold M.C. to switch the Bluetooth
device address and device name.
3 Press M.C. to connect the selected device.
! To complete the connection, check the device
name ( Pioneer BT Unit). Enter the PIN code
on your device if necessary.
! PIN code is set to 0000 as the default. You
can change this code.
! 6-digit number appears on the display of this
unit. Once the connection is established, this
number disappears.
! If you are unable to complete the connection
using this unit, use the device to connect to
the unit.
! If three devices are already paired, Device Full
is displayed and it is not possible to perform
this operation. In this case, delete a paired de-
vice first.
Special device (setting a special device)
Bluetooth devices that are difficult to establish a con-
nection with are called special devices. If your
Bluetooth device is listed as a special device, select
the appropriate one.
1 Press M.C. to display the setting mode.
! If three devices are already paired, Device Full
is displayed and it is not possible to perform
this operation. In this case, delete a paired de-
vice first.
2 Turn M.C. to display a special device. Press to se-
lect.
3 Turn M.C. to display this unit’s device name,
Bluetooth device address and PIN code.
4 Use a device to connect to this unit.
! To complete the connection, check the device
name ( Pioneer BT Unit) and enter the PIN
code on your device.
! PIN code is set to 0000 as the default. You
can change this code.
Auto connect (connecting to a Bluetooth device
automatically)
1 Press M.C. to turn automatic connection on or
off.
Visibility (setting the visibility of this unit)
En
18
Section
02 Operating this unit