Pioneer AVH-X8500BT User Manual

Page 8

1 Dashboard
2 Holder

(factory-supplied part)

Install this unit.

1 Dashboard

Installation using the screw
holes on the side of the unit

% Fastening the unit to the factory radio-
mounting bracket.
Position the unit so that its screw holes are
aligned with the screw holes of the bracket, and
tighten the screws at three locations on each
side.

1 If the pawl gets in the way, bend it down.
2 Factory radio mounting bracket
3 Use either truss (5 mm × 8 mm) or flush sur-

face (5 mm × 9 mm) screws, depending on
the bracket screw holes.

4 Dashboard or console

Note

In some types of vehicles, discrepancy may
occur between the unit and the dashboard. If
this happens, use the supplied frame to fill the
gap.

Removing the unit

Remove the trim ring.

1 Trim ring
! Releasing the front panel allows easier ac-

cess to the trim ring.

Insert the supplied extraction keys into

both sides of the unit until they click into
place.

Pull the unit out of the dashboard.

Installing the microphone

CAUTION

It is extremely dangerous to allow the micro-
phone lead to become wound around the steer-
ing column or shift lever. Be sure to install the
unit in such a way that it will not obstruct driv-
ing.

Note

Install the microphone in a position and orienta-
tion that will enable it to pick up the voice of the
person operating the system.

When installing the microphone
on the sun visor

Fit the microphone lead into the groove.

1 Microphone lead
2 Groove

Install the microphone clip on the sun

visor.
With the sun visor up, install the microphone
clip. (Lowering the sun visor reduces the voice
recognition rate.)

Installation

Section

Installation