Pioneer CDJ-100S - Manual (Page 10)

10
En
BASIC OPERATION II
DJ PLAYER OPERATIONS
Setting a Cue Point
Once a cue point is recorded in the memory, pressing
the CUE button causes the unit to enter the playback
standby mode at the cue point.
1. During playback, when the disc comes to the
point you wish to cue, press the PLAY/PAUSE
button (
6) to enter standby mode.
2. Rotate the jog dial to search for the desired
location.
÷ To set the cue point while listening to the sound,
use the jog dial to return the disc to a point just
before the point at which you wish to begin play-
back from the cue. (The cue point is that point im-
mediately after the sound heard in the audible
pause mode. )
3. When the frame number or the audible sound
reaches the desired cueing point, press the
CUE button.
÷ When the sound is muted and the cue indicator
(CUE) lights, the cue point has been stored in
memory.
÷ Each time a new cue point is stored in memory,
any previously stored cue point is erased.
Playback Operations with Auto Cue
Function ON
These represent basic playback operations when the auto
cue function is on (the display’s A.CUE indicator is lit).
1. Insert disc.
÷ With the disc's label surface upward, insert the disc
into the front-panel's disc loading slot.
÷ When playing an 8 cm/3-inch disc, place the disc
in a commercially available CD adapter before in-
serting in the loading slot.
÷ Load only one disc at a time.
Jog dial Jog dial
CAUTION
Do not attempt to press a disc back into the slot when the
EJECT indicator appears. Pressing a disc back into the slot
while the EJECT indicator appears may cause the player
to stop. In this case, press the EJECT button again and
wait until the EJECT indicator goes out before reinserting
the disc.
2. Press the PLAY/PAUSE button ( 6).
÷ Press after the CUE button’s indicator has lighted.
Playback will begin immediately.
7 When playback of one track ends, the player advances
to cue the beginning of the next track and enters the
standby mode. The CUE indicator lights, and the PLAY/
PAUSE button’s indicator flashes indicating the unit
is in playback standby mode. When the PLAY/PAUSE
button (
6) is pressed, the cued track will playback
immediately.
÷ Cueing is performed at the rate of 48 frames per
rotation of the jog dial.
7 Operation using the SEARCH buttons
With the unit in the standby mode, press one of the
SEARCH buttons (
1, ¡ ).
÷ Each time the button is pressed, the disc will move
one frame in the indicated direction.
Cueing by Frames
7 Jog dial
During playback, press the PLAY/PAUSE button ( 6)
to enter standby mode, then rotate the jog dial to
cue by frame (75 frames = 1 second).
÷ Cueing is performed in increments of single frames
by rotating the jog dial.
÷ When the jog dial is rotated clockwise, the player
cues forward; rotate counterclockwise to cue in the
reverse direction.