Pioneer CNDV-110MT - Manual (Page 6)

The programme is installed to the navigation
system using the application disc.
When installing the programme, you carry out
the following operations. When all the setup
procedures are completed, you can use the
navigation system.
The screen images used in this section are
AVIC-X1R as an example.
CAUTION
You cannot go back to the previous (pre-
upgrade) version of the application after
the software upgrade is completed. Also,
the map discs that were previously used
cannot be used. Instead, use the CNDV-
110MT DVDs as your new map discs.
1 Park your vehicle in a safe place.
Leave the engine on, and make sure that the
handbrake is applied.
2 Press EJECT button to remove the cur-
rent disc.
3 Insert the new Pioneer DVD Map Disc
into the appropriate slot.
When the upgraded programme has been
found, installation of the programme starts im-
mediately.
p If you cannot insert a disc completely or if
an inserted disc is not recognised, check
that the label side of the disc is up. Press
EJECT button to eject the disc, and check
the disc for damage before inserting the
disc again.
CAUTION
While this screen is visible, NEVER switch the
ignition key position or turn off the power of na-
vigation system.
When the installation is complete, the opening
display appears.
p By upgrading AVIC-X1 or AVIC-X1BT with
these discs, the same screen appears.
p By upgrading other models with these
discs, the following opening display ap-
pears.
16
Engb
Instructions for
upgrading
4 Press the NAVI/AV button to change
the navigation screen.
Some time is needed until navigation is ready.
5 Check the details of the caution mes-
sage and touch [OK].
The map of your surroundings is displayed.
You can operate the navigation system by
touching keys displayed on the screen as
usual.
When upgrading AVIC-X1, perform the following pro-
cedure.
6 To set the time difference, touch [+] or
[ –].
Time difference
The time difference between the time origin-
ally set in the navigation system (Central Eur-
opean Time) and the current location of your
vehicle is shown. If necessary, adjust the time
difference. Touching [
+] or [ –] changes the
time difference display in one-hour incre-
ments. The time difference can be set from
+3
to
–3 hours.
7 If necessary, set to summer time.
Summer time setting is off by default. Touch
[
Summer Time] to change the setting if you
are in the summer time period.
8 To complete the setting, touch [Back].
The map of your surroundings appears.
17
Engb
Instructions for
upgrading
18