Vitek VT-1708 - Manual (Page 3)

TO ASSEMBLE
1. Install multidirectional rolling wheels to each end between the first and the second
groups of the radiating flanges.
2. Let the "U" shape screw surrounding the dome of the radiating flanges. Then insert it
into two holes of the supporting plate.
3. Insert the butterfly nuts and screw them tightly counter clockwise.
4. Combine the tube and plastic rack together as figure.
5. Insert the towel rack assembly to radiator fins along the slot as figure.
TO USE
1. Insert the plug into the suitable wall outlet.
1) Never use the unit in place where is not plain, make sure there is nothing flammable or
easy deform object within 1m.
2) Insert the plug after setting the thermostat to the "OFF" position and setting the power
selected switches to the " OFF" position.
3) The unit should be earthed. Do not cover the appliance.
4) The heater is suitable for operation on an AC electricity supply having the same volt
age as that show on it's rating label.
2. Press the power selected switch to the "HIGH" position then turn thermostat to the
"HIGH" position, at this moment, the unit begins working, when the temperature rises
to what you are satisfied with, slowly turn thermostat counter clockwise until the indi
cating light of the key for power choice is out, and the room temperature thus can be
kept constant. If you want to raise or lower the room temperature, you can make
another regulation: Turn the thermostat clockwise to raise the temperature, or count
er clockwise to lower it and you can also turn the power switch to "LOW" or "MID" posi
tion for different power selecting.
3 10
ENGLISH
New 1708.qxd 12.05.03 16:34 Page 6