Pioneer DVH-P500UB - Manual (Page 52)

Setting the FM tuning step
Normally the FM tuning step employed by
seek tuning is 50 kHz. When AF or TA is on,
the tuning step automatically changes to 100
kHz. It may be preferable to set the tuning step
to 50 kHz when AF is on.
! The tuning step remains at 50 kHz during
manual tuning.
1 Use MULTI-CONTROL to select FM STEP.
Refer to Adjusting initial settings on the pre-
vious page.
2 Press MULTI-CONTROL to select the FM
tuning step.
Pressing
MULTI-CONTROL repeatedly will
switch the FM tuning step between 50 kHz
and 100 kHz. The selected FM tuning step will
appear in the display.
Switching Auto PI Seek
The unit can automatically search for a differ-
ent station with the same programming, even
during preset recall.
1 Use MULTI-CONTROL to select AUTO PI.
Refer to Adjusting initial settings on the pre-
vious page.
2 Press MULTI-CONTROL to turn Auto PI
seek on.
# To turn Auto PI seek off, press
MULTI-CONTROL again.
Switching the warning tone
If the front panel is not detached from the
head unit within five seconds of turning off the
ignition, a warning tone will sound. You can
turn off the warning tone.
1 Use MULTI-CONTROL to select
WARNING.
Refer to Adjusting initial settings on the pre-
vious page.
2 Press MULTI-CONTROL to turn warning
tone on.
# To turn warning tone off, press
MULTI-CONTROL again.
Switching the auxiliary setting
Auxiliary devices connected to this unit can be
activated individually. Set each AUX source to
ON when using. For more information about
connecting or using auxiliary devices, refer to
Using the AUX source on page 56.
Switching the auxiliary 1 setting
1 Use MULTI-CONTROL to select AUX1.
Refer to Adjusting initial settings on the pre-
vious page.
2 Press MULTI-CONTROL to select desired
setting.
! VIDEO – an iPod with video capabilities
connected with 4-pole mini plug cable (e.g.,
CD-V150M)
! AUDIO – auxiliary device connected with
stereo mini plug cable
! OFF – No auxiliary device is connected
Switching the auxiliary 2 setting
1 Use MULTI-CONTROL to select AUX2.
Refer to Adjusting initial settings on the pre-
vious page.
2 Press MULTI-CONTROL to turn AUX2
on.
# To turn AUX2 off, press MULTI-CONTROL
again.
Operating this unit
En
52
Section
02