Pioneer DJM-600 - Manual (Page 15)

15
1 4
70-139
BPM
91-180
BPM
BPM
3
AUTO BPM COUNTER
2
1
MASTER
4 MIC
BPM
3
PARAMETER1
2
1/2 1/1 4/1 2/1 3/4
1 4
BEAT
16 8 2
USING THE EFFECT/SAMPLER FUNCTIONS
Measuring BPM in Manual Mode
7 When BPM cannot be measured in auto BPM mode:
If auto BPM measurement is not possible, use the tap
switch for manual input.
÷ When the tap switch is pressed in time to the music’s
beat, the light in both BPM measurement range
displays will turn off and manual mode will go into
effect.
÷ The BPM value input with the tap switch will be
displayed on the effector/BPM display’s lower counter,
and the display on the upper counter will turn off.
÷ To return to auto BPM mode, press the BPM
measurement range selector switch and set the
measurement range.
7 When BPM cannot be measured during delay, echo,
auto pan, auto trans, filter and flanger operations
(pages 16 and 17), or during sampler operations
(pages 20 and 21):
If BPM cannot be measured for more than 2 seconds
during effect or sampler operations, the BPM display’s
counter will blink. In such a case, change the effect/
sampler selector switch to AUTO BPM and use the tap
switch for manual input.
÷ After the BPM value input via the tap switch has been
displayed on the effect parameter/BPM display’s lower
counter and the effect/sampler selector switch
restored to the original effect, the BPM value input will
be displayed on the BPM display’s upper counter.
BPM can be input in manual mode if the music’s BPM is
known in advance.
÷ Change the effect/sampler selector switch to AUTO
BPM and press the BPM measurement range selector
switch and both BPM measurement range displays will
turn off.
÷ If the effect/sampler parameter 1 knob (TIME) is
pressed, the counter on the effect parameter/BPM
display will display the BPM, with adjustment possible
from the first digit.
Turning the parameter 1 knob while pressing the tap
switch makes it possible to adjust the BPM from the
first decimal place.
When the BPM value has been set and the effect/
sampler selector switch restored to the original effect,
the BPM value set will be displayed on the BPM
display’s counter.
BPM display
Effect parameter/
BPM display
Counter
Counter
BPM measurement
range selector
switch
BPM measurement
range display