Pioneer MEH-P9100R - Manual (Page 54)

53
Audio Adjustment
Non-Fading Output (Non Fad
E
-1)
When the Non-Fading Output setting is ON, the audio signal does not pass through this
unit’s low pass filter (for the Subwoofer), but is output through the RCA output.
Note:
• When the Subwoofer Controller setting is only “Sub woofer control External”, you can switch the
Non-Fading Output ON/OFF mode. (Refer to page 66.)
Non-Fading Output Level Adjustment (Non Fad
E
-2)
When the Non-Fading output is ON, you can adjust the level of Non-Fading output.
Note:
• You can select the Non-Fading Output setting mode only when Non-Fading output is switched ON
in the Non-Fading Output ON/OFF mode.
2. Increase or decrease the output
level with the
5/∞ buttons.
The display shows “0” – “–15”.
1. Select the Non-Fading Output setting mode (Non Fad
E
-2) in the Audio
Menu 2. (Refer to page 51.)
2. Switch the Non-Fading output
ON/OFF with the
5/∞ buttons.
1. Select the Non-Fading Output ON/OFF mode (Non Fad
E
-1) in the Audio
Menu 2. (Refer to page 51.)