Pioneer X-EM21 - Manual (Page 13)

Getting started 04
13
En
English
Français
Español
Chapter 4:
Getting started
CAUTION
• Use of controls or adjustments or performance of
procedures other than herein expressly specified may
result in hazardous radiation exposure or other unsafe
operation.
Always follow the instructions in this chapter in sequence.
Turning on
 Press  STANDBY/ON
This product switches to the last selected source.
APS mode
• After this product is kept inactive for 15 minutes, it
automatically switches to the standby mode.
– The clock is displayed.
– If the clock is not set, [--:--] blinks.
How to turn off the APS mode:
• Press and hold  to turn off the APS mode in the
standby mode and [APS OFF] is displayed.
• If the APS mode is turned on again, Press and hold 
in the standby mode and [APS ON] is displayed.
Note
• When an iPod/iPhone is connected, the light of the main
display stays on even if it automatically switches to the
standby mode.
Setting the clock
Note
• During setting, if no action is made within 90 seconds, the
system exits clock setting without saving earlier
operations.
1 In the standby mode, press and hold
DISPLAY/CLOCK to activate clock setting.
The hour digits blink.
2 Press / to set the hour, and then
press DISPLAY/CLOCK to confirm.
The minute digits blink.
3 Press / to set the minute, and then
press DISPLAY/CLOCK to confirm.
Selecting a source
Press INPUT repeatedly to select a source.
• [DISC]: the disc in the disc tray
• [USB]: .wma/.mp3 files stored on the connected USB
storage device
• [iPod]: the playlist on the connected iPhone/iPod
(X-EM21 only)
• [FM ST]/[FM MONO]: the FM radio
• [AUX IN]: the audio input through the AUX IN socket
X-EM21_SYXE8_En.book Page 13 Thursday, June 7, 2012 9:43 AM
601-EM2100-010.pdf 13 2012/7/5 11:25:05