Belkin F5D5020T - Manual (Page 4)

Installing the Hardware
2
Installing the Notebook Network Card in PCs with PCMCIA Slots
1. Turn off the power to the notebook.
2. Insert the Notebook Network Card in the PCMCIA slot of
your notebook.
3. Connect the Notebook Network Cards adapter into the connector on
the rear of the card.
4. Connect the other end of the
CAT 5 cable and RJ45 plug
into the network device.
Note: A standard Belkin network
cable cannot be used to
directly connect two
computers. A specially wired cable called a crossover cable is
needed to allow you to connect two computers without the use of
a network hub or switch. Belkin crossover cables are yellow
(Belkin’s A3X126-XX-YLW-M).