Pioneer MEH-P7300R - Manual (Page 9)

8
ENGLISH
ESPA
Ñ
OL
DEUTSCH
FRAN
Ç
AIS
ITALIANO
NEDERLANDS
Installing the Unit on a Left-Hand-
Drive Car
Note:
• When the unit is installed on a right-hand-drive
car, the horizontal positions are inverted.
1. Secure inner holder to the inner cir-
cumference of the steering wheel
with belt. (Fig. 7)
• Fit the inner holder to the steering wheel so
that the arrow-marked side faces the driver as
shown below.
Fig. 7
2. Cut the extra portion of the belt at
the center of the inner holder.
(Fig. 8)
Fig. 8
3. Install outer holder on the inner
holder and secure with screws.
(Fig. 9)
• Tighten the screws with the supplied hexago-
nal wrench.
Fig. 9
4. Install the remote control unit in
the holder. (Fig. 10)
• When removing the remote control unit from
the holder, move the corrugated release sec-
tion toward the steering wheel and slide the
remote control unit toward you.
Fig. 10
Belt
Inner holder
Screw
Outer holder
Release Section