Pioneer S-ESR2TB - Manual

1
En
S-ESR2CR Operating Instructions
Speaker System
WHAT’S IN THE BOX
BEFORE USE
Thank you for buying this Pioneer product.
Please read through these operating instructions before
using your speaker system to optimize performance.
• This speaker system has an impedance of 8 Ω, and
should be connected only to an amplifier designed
with a load impedance of 8 Ω (the amplifier’s speaker
output connector should clearly be labeled “8 Ω“).
• In order to prevent damage to the speaker system
resulting from input overload, please observe the
following precautions:
-Be sure to turn the connected devices off and
remove the power cord from the wall outlet
beforehand when changing the connection or
installation method.
-Do not use excessive amplifier volume if using a
tone control to emphasize high or low frequencies.
• Do not use the speaker to output distorted sound for
long periods of time. This can result in a fire hazard.
INSTALLATION PRECAUTIONS
• Do not install these units near a stove or other
heating appliance, or put them in a place exposed to
the sun. Such locations may cause the cabinet to
change color and the speaker system to break down.
• Do not place the speaker on an unstable surface, as
doing so may cause the speaker to fall and cause
damage or bodily injury.
CENTER SPEAKER
• Do not attach the center speaker to the wall or
ceiling. It may fall off and cause injury.
• This speaker system is magnetically shielded.
However, depending on the installation location,
color distortion may occur if the speaker system is
installed extremely close to the screen of a television
set.
If this happens, turn off the television, then turn it on
again after 15 min to 30 min. If the problem persists,
place the speaker system away from the television
set.
• Do not install your speakers overhead on the ceiling
or wall. The grille is designed to be detachable, and
as such it may fall and cause damage or personal
injury if installed overhead.
SURROUND SPEAKERS
• The surround speakers are not magnetically shielded
and so should not be placed near a TV or monitor, as
the interaction of magnetic materials can cause
distortion of the colors on your TV screen. Magnetic
storage media (such as floppy discs and tape or video
cassettes) should also not be kept close to these
speakers.
PLACEMENT AND FINE TUNING
CENTER SPEAKER
The speaker should be positioned below the TV. For best
results align the front of the speaker with the front of the
TV. If the speaker is placed under the TV and very close to
the floor, then tilting upwards may be beneficial.
Do not place the center speaker on top of TV, the speaker
may fall from the TV due to external shocks such as
earthquakes, endangering those nearby or damaging the
speaker.
Surround speakers x 2
Speaker cords x 3
Center speaker x 1
Non-skid pads x 12
(4 pcs x 3 sheets)
Operating instructions
Center
(2 m, Tie color : Black)
Surround right / left
(10 m, Tie color : Red)
S-ESR2CR_En.fm 1 ページ ２０１１年２月１６日 水曜日 午後２時２９分