Pioneer VSX-818V-K - Manual (Page 25)

Controls and displays 04
25
En
English
Français
Deutsch
Nederlands
Italiano
Español
ANALOG
Lights when an analog signal is detected.
DTS
Lights when a source with DTS encoded
audio signals is detected.
2
Lights to indicate decoding of a DTS multichannel
signal.
3 2 DIGITAL
Lights to indicate decoding of a Dolby Digital
multichannel signal.
4 2 PRO LOGIC II
Lights to indicate Pro Logic II decoding (see
Listening in surround sound on page 30).
5 VIR. SB
Lights during Virtual surround back processing
(page 33).
6 DIRECT
Lights when source Stream Direct playback is in
use. Direct playback bypasses the tone controls
for the most accurate reproduction of a source.
7 AUTO SURR.
Lights when the Auto Surround feature is
switched on
(see Auto playback on page 30).
8 ATT
Lights when ANALOG ATT is used to attenuate
(reduce) the level of the analog input signal
(page 28) .
9 SLEEP
Lights when the sleep mode is active (page 28).
10 Tuner indicators
/ MONO
Lights when the mono mode is set using
the
MPX button.
/ STEREO
Lights when a stereo FM broadcast is being
received in auto stereo mode.
/ TUNED
Lights when a broadcast is being received.
11 EON / RDS indicators
EON
Lights when the EON mode is set, and
flashes during an EON broadcast. The
indicator lights when the current station
carries the EON service (page 49).
RDS
Lights when an RDS broadcast is received
(page 48).
12 Speaker indicators
Lights to indicate the current speaker system,
A and/or B (page 22).
13 Character display
14 ADV.SURR. (Advanced Surround)
Lights when one of the Advanced Surround
modes has been selected.
15 WMA9 Pro
Lights to indicate decoding of a WMA9 Pro
signal.
16 MIDNIGHT
Lights during Midnight listening (page 34).
17 D.E.
Lights when Dialog Enhancement is switched
on (page 35).
18 LOUDNESS
Lights during Loudness listening (page 34).
19 Master volume level
Shows the overall volume level.
20 MCACC channel EQ / Sound Retriever /
HDMI indicators
These indicators show the EQ balance for each
channel in Checking your Acoustic Calibration
EQ settings
on page 42. Also, L and R light
when the Sound Retriever is active (page 32).
In addition, the HDMI connection state is
displayed as shown below.
Blinks when connecting an HDMI-equipped
component: lights when the component is
connected (page 16).
6
6
0
L
C
R
Ls
Rs
[ ]
[ ]
[ ]
[ ]
[ ] HDMI indicator
VSX_918_818_MY.book 25 ページ ２００７年１２月２７日 木曜日 午後４時２７分