Pioneer CP-4EX - Manual (Page 2)

2
En
Thank you for buying this Pioneer product. This speaker stand
should only be used with the S-4EX Pioneer speaker system.
Please read through these operating instructions for proper
assembly and use. After you have finished reading the
instructions, put them away in a safe place for future reference.
Before you start
Before setting up your speaker system, we recommend reading
the operating instructions for your system thoroughly.
• Do not use this speaker stand with speakers other than the
Pioneer S-4EX, since the product balance may be impaired,
resulting in tipping or dangerous falls.
• Only use the screws supplied when fixing the speaker to the
speaker stand.
• Do not place the stand on an unstable and/or sloping surface.
The stand and speaker may fall and cause injury.
• Do not use with any speaker system other than the one for
which the unit was designed. The stand may collapse and be
damaged and/or the speaker may fall and cause injury.
• When moving the speaker and stand, first remove the speaker
from the stand, and then move the stand, holding it by the
stems.
• Place the stand on a stable, level surface; placing the stand on
an unstable surface can be dangerous.
• Pioneer assumes no liability whatsoever for damages
resulting from assembly, improper mounting, insufficient
reinforcement, misuse of the product, acts of nature, etc.
Names of Parts
Attaching speakers to the
stands
A medium Phillips screwdriver is required for attaching the
speakers.
Assembly with the S-4EX speaker
system
If you are using the S-4EX speaker system, note that there is a
fastening nut provided on the speaker base (see below).
When installing spikes on speaker
Use only spikes supplied with S-4EX.
1 Set spikes into three locations on bottom of speaker.
Consult the S-4EX operating instructions for additional
instructions.
2 Apply the furnished cork plates on the three locations on
the speaker support.
3 Rest the speaker gently on the speaker support while
aligning the spikes with the cork plates on the top of the
speaker support, then fix in placing using the washers,
spring washers, and screws (bind head M5 x L55).
Speaker support
Stand stems
Stand base
Screw holes
for securing speaker
Non-skid
cork pads
Speaker
support
Cork plates
[SEC2255]
55 mm
Black
Speaker base
Speaker
support
Screw holes
for securing
speaker
Fastening nut
Washer
[SBE6006]
Spring washer
[SBE6005]
Screws
(Bind head, M5 x L55)
[SBA1307]
Cork plates
01_CP-4EX_EN.fm 2 ページ ２００８年７月２４日 木曜日 午後１２時５０分