Pioneer DDJ-ERGO-K - Manual (Page 21)

21 En
Advanced
Operation
Advanced Operation
Using the CUE function
1 In the pause mode, press the [CUE] button to set a cue
point at the position at which playback is paused.
2 When the [CUE] button is pressed during playback,
playback returns to the cue point that was set directly
before and pauses (Back Cue).
3 After returning to the cue point, keep pressing the
[CUE] button to continue playing (Cue Sampler).
Using the LOOP function
Manual looping
1 During playback, press the [IN] button to set the loop
in point.
2 Press the [OUT] button to set the loop out point and
start loop playback.
! When the [OUT] button is pressed during loop playback, loop play-
back is canceled.
Auto looping
1 During playback, turn the [AUTO LOOP] control to set
the length for loop playback in number of beats.
2 Press the [AUTO LOOP] control to start loop playback.
! The length of the loop can be changed by turning the [AUTO LOOP]
control during loop playback.
! When the [AUTO LOOP] control is pressed during loop playback,
loop playback is canceled.
Using the EFFECT function
Separate audio effects can be applied to the respective decks.
1 Turn an effect parameter control while pressing the
[SHIFT] button to select the effect type.
2 Press an effect parameter button.
3 Turn the effect parameter controls to adjust the
parameters of the respective effects.
Switching the jog dials’ illumination
mode
This unit is equipped with two types of illumination modes for the jog
dials.
Press the [VINYL (PULSE MODE)] button while pressing
the [SHIFT] button to switch the illumination mode.
— Pulse Mode Active: The offset of the beat grid is indicated by the
white illumination of the jog dials. The illumination is brightest
for the master deck and decks for which the beat grid matches.
The jog dials’ illumination also lights in association with the
operation of the [FILTER] control.
— Pulse Mode Normal: The white illumination lights when the top of
the jog dial is pressed.
! The illumination mode setting is not cleared when this unit’s power
is turned off. When the power is next turned on, the unit starts in the
mode that was set before the power was turned off.