Pioneer S-8EX-W - Manual (Page 11)

11
En
English
Other Information
Using the foam plugs
This unit is furnished with foam plugs that are useful for adjusting
the volume of bass sound. To use, place the foam plugs gently into
the bass reflex ports on either side of the speaker. Insert either
foam plug A alone, or both foam plugs A and B to achieve the
desired sound.
Using foam plugs A only
Using both foam plugs A and B
Attaching/Removing the Grille Cover
This speaker system comes with grille covers which may be
attached and removed by:
1 To attach the grille cover, line up the holes on the speaker
with the inserts on the grill, and press firmly.
2 To remove the grille cover, grasp the upper and lower
edges of the grille cover at the left side by your hands and
gently pull toward you to separate the left part of the grille
cover from the speaker.
3 Then move your hands to the middle of the grille cover
and again gently pull the upper and lower edges toward you
to separate the middle section.
4 Finally, grasp the upper and lower edges of the grille
cover at the right side and gently pull toward you to
separate the remaining part of the grille cover from the
speaker.
Cleaning the speaker cabinet
With normal use, wiping with a dry cloth should be sufficient to
keep the cabinet clean. If necessary, clean with a cloth dipped in
a neutral cleanser diluted five or six times with water, and wrung
out well. Do not use furniture wax or cleansers.
Never use thinners, benzine, insecticide sprays or other chemicals
on or near this unit since these will corrode the surfaces.
Bass reflex ports
Bass reflex ports
S-8EX_EN.book 11 ページ ２００８年７月１６日 水曜日 午後２時２０分