Pioneer PDK-TS07 - Manual (Page 8)

8
En
Assembling the Stand
1
Turn the base cover over so the underside is
facing up.
2
Insert the stand pipes into the base cover.
3
Tighten the screws (4 mm x 8 mm) to stabilize
the stand pipes.
Note
Assemble the stand with a soft sheet placed under the base
cover.
If a sheet is not laid before assembly, the front surface of the
base cover may be scratched.
Base cover
Screws
(4 mm x 8 mm)
Stand pipes
Screws
(4 mm x 8 mm)
Assembly Procedure
Sheet
Checking the Standard Accessories
Check to make sure that you have all the standard accessories before assembly and installation.
Base cover x 1 Stand pipes
(left and right, interchangeable) x 2
Hexagonal wrench x 1
(Opposite side 5 mm for M8 use)
Screws (4 mm x 8 mm) x 4
Installation bolts 1
(M8 x 20 mm) x 2
Installation bolts 2
(M8 x 40 mm) x 2
Operating instructions
(this document) x 1
Falling prevention
bolts x 2